X hits on this document

120 views

0 shares

0 downloads

0 comments

19 / 32

To Program the CBL Key:

1.

On the next page,locate the brand name of your Cable Converter in Setup Codes For Cable Converters,or DBS (Direct Broadcast Satellite) Receiver in Setup Codes For DBS Receivers,and write it in the appropriate space below.

Cable Converter Brand: ________________ or DBS Receiver Brand: __________________

The brands are listed in alphabetical order with the most popular codes listed first.You will use one of these codes to reprogram the Millennium 4 to operate your Cable Converter or DBS Receiver.

  • 2.

    On the Millennium 4,press CBL once.Press and hold SETUP until the LED blinks twice, then release SETUP.

  • 3.

    Enter the first four-digit code for your Cable Converter or DBS Receiver.If you perform this procedure correctly,the LED will blink twice.

NOTE: f the LED did not blink twice after entering the code’s last digit, then repeat steps 2 through 3 and try entering the same code again.

  • 4.

    Aim the Millennium 4 at your Cable Converter or DBS Receiver and press POWER once.The unit should turn off.If it does not respond, repeat steps 2 and 3,trying each code listed for your brand until you find one that works.If it still does not work ,try searching for the code (see Searching For our Code on page 24).

  • 5.

    For future reference,write your device’s code and type in the boxes and space below.

Device Type:________________________

NOTE: Remembe , to use the Millennium 4 to operate your Cable Converter or DBS Receive , press CBL first.

continued on next page...

19

Document info
Document views120
Page views120
Page last viewedWed Jan 18 16:59:14 UTC 2017
Pages32
Paragraphs1065
Words6058

Comments