X hits on this document

97 views

0 shares

0 downloads

0 comments

25 / 32

CHECKING THE CODES

If you have set up the Millennium 4 using the Searching For our Code procedure,you may need to find out which four-digit code is operating your equipment:

For example,to find out which code is operating your TV:

  • 1.

    Turn on your TV.

  • 2.

    On the Millennium 4,press and hold SETUP until the LED blinks twice,then release SETUP.

  • 3.

    Enter 9 - 9 - 0.The LED will blink twice.

  • 4.

    To view the code for the first digit,press 1 once. Wait 3 seconds and count the number of LED blinks (e.g.,3 blinks = 3) and write down the number in the leftmost TV Code box below. NOTE: f a code digit is“0”, the LED will not blink.

  • 5.

    Repeat step 4 three more times for remaining digits.Use 2 for the second digit,3 for the third digit,and 4 for the fourth digit.Finish writing down the code in the TV Code boxes below.

  • 6.

    To check for the codes of your other components,repeat steps 1 through 5,but substitute the appropriate key (i.e.,VCR,CBL, or AUDIO) for the (VCR or DVD,Cable,or Audio) component you are checking.Write down the codes in the appropriate boxes below. TV Code

VCR (or DVD Player) Code

CBL Code

AUDIO

Code

___________________

25

Document info
Document views97
Page views97
Page last viewedFri Dec 09 04:29:35 UTC 2016
Pages32
Paragraphs1065
Words6058

Comments