X hits on this document

99 views

0 shares

0 downloads

0 comments

26 / 32

RE-ASSIGNING DEVICE KEYS

The Millennium 4 can be set up to control a second TV or VCR, or any combination of four home entertainment components. For example, to have the Millennium 4 control a TV, a Cable Converter, and two VCRs, you will need to re-assign the unused AUDIO key to operate the second VCR as follows:

1.

On the Millennium 4,press and hold SETUP until the LED blinks twice,then release SETUP.

  • 2.

    Enter 9 - 9 - 2.The LED will blink twice.

  • 3.

    Press VCR once,then press AUDIO once.

  • 4.

    The AUDIO key is now ready to be programmed

for your secondVCR.See Programming VCR/DVD Player Control on page 12.

To re-assign other device keys,repeat steps 1 through 4 by substituting the key sequence from the following chart for

a desired component To Re-Assign TV as 2nd VCR key: TV as 2nd Audio key: TV as 2nd Cable key: TV back to TV: VCR as 2nd TV key: VCR as 2nd Audio key :

Perform Key Sequence SETUP - 9 - 9 - 2 - VCR - TV SETUP - 9 - 9 - 2 - AUDIO - TV SETUP - 9 - 9 - 2 - CBL - TV SETUP - 9 - 9 - 2 - TV - TV SETUP - 9 - 9 - 2 - TV - VCR : SETUP - 9 - 9 - 2 - AUDIO - VCR

VCR as 2nd Cable key: SETUP - 9 - 9 - 2 - CBL - VCR

VCR back to VCR:

SETUP - 9 - 9 - 2 - VCR - VCR

AUDIO as 2nd TV key: SETUP - 9 - 9 - 2 - TV - AUDIO AUDIO as 2nd VCR key: SETUP - 9 - 9 - 2 - VCR - AUDIO AUDIO as 2nd Cable key: SETUP - 9 - 9 - 2 - CBL - AUDIO

AUDIO back to AUDIO:

SETUP - 9 - 9 - 2 - AUDIO - AUDIO

Upon completion of a re-assignment,the LED will blink twice to confirm your selection.At that time,you will also need to program the Millennium 4 to control the new component.See previous sections on Programming TV Control,Programming VCR/DVD Player Control, Programming Cable Converter (or DBS Receiver) Control, or Programming Audio Control.

26

Document info
Document views99
Page views99
Page last viewedFri Dec 09 15:49:38 UTC 2016
Pages32
Paragraphs1065
Words6058

Comments