LED does not blink when you press a key.
SOLUTION: Replace the batteries with two (2) new AA alkaline batteries (see page 7).
LED blinks when you press a key,but home entertainment component does not respond.
SOLUTION: Make sure you are aiming the Millennium 4 at your home entertainment component and that you are within 15 feet of the component you are trying to control.
The Millennium 4 does not control home entertainment components or commands are not performing properly.
SOLUTION: Try all listed codes for the component brand
being set up. Make sure all components can be operated with an infrared remote control.
TV/VCR combo does not respond properly.
SOLUTION: Use the VCR codes for your brand. Some combo units may require both a TV code and a VCR code for full operation (see page 16).
No volume on a second TV. Follow instructions in Changing Volume Lock
(see page 27).
CH+ , CH- , and LAST do not work for your RCA TV.
: Due to RCA design (1983-1987),only the original remote control will operate these functions.
Changing channels does not work properly.
SOLUTION: If original remote control required pressing ENTER to change channels,press ENTER on the Millennium 4 after entering a channel number.
Tried“Search Method”and still could not find a working code.
SOLUTION: Try the“Search Method”again after clearing out the device key as follows: Press and hold SETUP until the LED (red light) blinks twice,then release.Next enter 9 - 9 - 2.Then press and release the device key to be cleared twice.
Remote control does not turn on Sony or Sharp TV/VCR Combo.
SOLUTION: For power on,these products require program- ming TV codes on the Millennium 4.For Sony, use TV code 0000 and VCR code 0032.For Sharp, use TV code 0093 and VCR code 0048.