General Safety Recommendations
The practical or possible fabrication area is to be setup to perform as much of the fabrication work.
Local exhaust ventilation should be provided at areas of cutting and tapering to remove airborne dust and fibers. General dilution ventilation should be provided as necessary to keep airborne dust and fibers below the applicable exposure limits and guidelines.
Work area should be kept clean, including floor or other horizontal surfaces. Rinsing with water or sweeping with brushes or brooms (using floor sweep) is recommended. Brushes should be used to remove residue from shaved surfaces.
Always refer to the Material Safety Data Sheet (MSDS) prior to working with unfamiliar materials or if there are questions concerning the contents of the fiberglass pipe.