X hits on this document

1008 views

0 shares

0 downloads

0 comments

44 / 236

Interface Operation

Collector keywords Use the following keywords to define options for the EPILOG collector.

INTERVAL

This option sets the interval at which EPILOG collects, combines, and writes data to the EDS and SMF. This interval can be set to the RMF cycle or to any amount of time between 10 and 120 minutes (2 hours). The default is the RMF cycle, or 15 minutes if RMF is not installed or is not active.

DEGCYCLE

This option sets the cycle at which &E. collects bottleneck data, expressed in 100ths of a second. You can set this cycle to any value between 50/100 and 1000 (or between .5 and 10 seconds). The default is 500/100, or 5 seconds.

DBIO

This option specifies whether to collect statistics individually for each database. Bottleneck analysis is normally performed for all databases. If you specify YES for this option, EPILOG collects statistics for each individual active database. On a system with many active databases, the storage requirements for EPILOG database collection may be prohibitive. If this is the case, EPILOG sends a WTO message to the system console, and it stops individual database collection. Valid entries for this keyword are YES and NO. The default is NO.

SMFDATA

This option causes EPILOG to write the collected data to SMF as well as the EDS at the end of every collection interval. This option is the default.

NOSMFDATA SMFNUM (or SMFN)

This option causes EPILOG not to write to SMF.

This option sets a number from 0255 that represents the EPILOG ID for collected data. When EPILOG writes to SMF, it must have a way to separate this data from the data that SMF normally collects. Choose a record number that is not already in use. The default is 185.

Caution

Other Candle products (OMEGAMON II for MVS, EPILOG for IMS, and DELTAMON® for MVS) also write records to SMF. If any of these products is installed, be sure that OMEGAMON II for DBCTL does not use an SMF record number that is already assigned. Default numbers for these Candle products are:

Default 180

Product OMEGAMON II for MVS and its predecessor

182 and 183 185

EPILOG for MVS DELTAMON for MVS

OMEGAMON II for IMS and its predecessor EPILOG for IMS

44

OMEGAMON II for DBCTL Historical Component (EPILOG) Reference Manual Version 510

Document info
Document views1008
Page views1008
Page last viewedSat Dec 10 17:17:35 UTC 2016
Pages236
Paragraphs8116
Words69808

Comments