X hits on this document

1037 views

0 shares

0 downloads

0 comments

51 / 236

Starting the EPILOG Reporter

Starting the EPILOG Reporter

Steps

Follow these steps to begin using the EPILOG reporter: 1. Enter the command to start the EPILOG reporter.

The command that you enter depends on whether you are running EPILOG in ISPF mode, TSO mode, or batch mode. For more information on starting the reporter, refer to Installing Candle Products on MVS.

After you issue the command that starts the reporter, the first screen you see looks similar to Table 4 .

FIGURE 4. Copyright Screen

Copyright 1982, 1983, 1984, 1985, 1986, 1987, 1988, 1989, 1991, 1992, 1993, 1994, 1995 Candle corporation. All rights reserved. Use permissible by license only.

EPILOG/IMS +=============================================================================+

| | | | | | | | | | |

1

Date and Time Range ------------------------------- CANDLE.EP.SAMPLE.EDSB 01/02/97 09:00 - 01/22/97 08:15

Util ----

Xt ---

98%

18

Summary Data Store Statistics

Press ENTER to Continue

| | | | | | | | | | |

+=============================================================================+

This screen contains copyright information that safeguards Candles proprietary rights to OMEGAMON II and this product component. Following is information that identifies the EPILOG datastore that has been defined for the current reporter session, along with statistics for the datastore such as the creation date and time, the date and time the EDS was last updated, the percentage of utilization, and the number of extents.

2. Press Enter.

The next panel shows EPILOGs default program function (PF) key settings as shown in Figure 5 on page 52:

Reporter Operator

51

Document info
Document views1037
Page views1037
Page last viewedSun Dec 11 12:26:45 UTC 2016
Pages236
Paragraphs8116
Words69808

Comments