X hits on this document

134 views

0 shares

0 downloads

0 comments

28 / 47

belonging to Classes A ‘No contribution to fire’ provided for in Decision 94/611/EC implementing Article 20 of Council Directive 89/106/EEC on construction products

Commission Decision 2003/424/ECCommission Decision of 6 June 2003 amending Decision 96/603/EC establishing the list of products belonging to Classes A ‘No contribution to fire’ provided for in Decision 94/611/EC implementing Article 20 of Council Directive 89/106/EEC on construction products

7.2 Product Specifications

ETAG 026Fire Stopping and Fire Sealing Products - Part 1 – "General"

ETAG 018 Part 4Fire Protective Board, Slab and Mat Products and Kits

EN 1396Aluminium and aluminium alloys - Coil coated sheet and strip for general applications – Specifications

EN 10088Stainless steels –

Part 1: List of stainless steels

Part 2:Technical delivery conditions for sheet/plate and strip of corrosion resisting steels for general and construction purposes

Part 3:Technical delivery conditions for semi-finished products, bars, rods, wire, sections and bright products of corrosion resisting steels for general and construction purposes

EN 10169Continuously organic coated (coil coated) steel flat products –

Part 1: General information (definitions, materials, tolerances, test methods)

Part 2: Products for building exterior applications

Part 3: Products for building interior applications

EN 13162Thermal insulation products for buildings – Factory made mineral wool (MW) products - Specification

EN 13245Plastics – Unplasticised poly(vinyl) chloride (PVC-U) profiles for building applications –

Part 1: Designation of light coloured profiles

Part 2: Profiles for internal and external wall and ceiling finishes

Part 3: Designation of coloured profiles

EN ISO 12944Paints and varnishes - Corrosion protection of steel structures by protective paint systems –

Part 1: General introduction

Part 2:  Classification of environments

Part 3:  Design considerations

Part 4:  Types and surface preparation

Part 5:  Protective paint systems

Part 6:  Laboratory performance test methods

Part 7:  Execution and supervision of paint work

Part 8:  Development of specifications for new work and maintenance

EN ISO 14713Protection against corrosion of iron and steel in structures - Zinc and aluminium coatings – Guidelines

IEC 60439-1Low-voltage switchgear and controlgear assemblies – Part 1: Type-tested and partially type-tested assemblies

7.3 Test methods and classification standards

EN 763Plastics piping and ducting systems – Injection-moulded thermoplastics fittings – Test method for visually assessing effects of heating

EN 1015-11Methods of test for mortar for masonry – Part 11: Determination of flexural and compressive strength of hardened mortar

EN 1026 Windows and doors – Air permeability – Test method

EN 1366-3.2, 02/2006, draft 11c

Fire resistance tests for service installations – Part 3: Penetration seals

EN 1426Bitumen and bituminous binders - Determination of needle penetration

ETAG 026

28

Document info
Document views134
Page views134
Page last viewedSun Dec 11 06:16:45 UTC 2016
Pages47
Paragraphs2339
Words16195

Comments