X hits on this document

102 views

0 shares

0 downloads

0 comments

43 / 47

Addendum:Model ETA for ETA issued on the basis of ETAG 026, part 2]

Cover page of the ETA

according to Document 5.1 (new ETA),Document 5.2 (modified ETA) or Document 5.3 (ETA with extended period of validity), as relevant.

Page 2 of the ETA

with headline Page 2 of ETA-xx/xxxx, issued on dd.mm.yyyy[, validity extended on dd.mm.yyyy]

ILEGAL BASES AND GENERAL CONDITIONS

1This European Technical Approval is issued by ...(name of approval body) in accordance with:

Council Directive 89/106/EEC of 21 December 1988 on the approximation of laws, regulations and administrative provisions of Member States relating to construction products24 modified by Council Directive 93/68/EEC25 and Regulation (EC) N° 1882/2003 of the European Parliament and of the Council26;

...(indicate respective national law transposing the CPD; only if the national law of the Member State of the issuing approval body so requires);

Common Procedural Rules for Requesting, Preparing and the Granting of European Technical Approvals set out in the Annex to Commission Decision 94/23/EC27;

Guideline ...(indicate title and number of ETA Guideline on the basis of which the ETA is granted, unless ETA is issued without an ETA Guideline in accordance with point 3.2 of the Common Procedural Rules, pursuant to Article 9(2) of the CPD).

2The ...(name of issuing approval body) is authorized to check whether the provisions of this European Technical Approval are met. Checking may take place in the manufacturing plant(s). Nevertheless, the responsibility for the conformity of the products to the European Technical Approval and for their fitness for the intended use remains with the holder of the European Technical Approval.

3This European Technical Approval is not to be transferred to manufacturers or agents of manufacturers other than those indicated on page 1, or manufacturing plants other than those /indicated on page 1/ laid down in the context/ of this European Technical Approval (delete as appropriate).

4This European Technical Approval may be withdrawn by ...(name of issuing approval body), in particular pursuant to information by the Commission according to Article 5(1) of Council Directive 89/106/EEC.

5Reproduction of this European Technical Approval including transmission by electronic means shall be in full. However, partial reproduction can be made with the written consent of ...(name of issuing approval body). In this case partial reproduction has to be designated as such. Texts and drawings of advertising brochures shall not contradict or misuse the European Technical Approval.

6The European Technical Approval is issued by the approval body in its official language(s). This (These) version(s) corresponds (correspond) fully to the version circulated in EOTA. Translations into other languages have to be designated as such.

Page 3 and following pages of the ETA

with headline Page ... of ETA-xx/xxxx, issued on dd.mm.yyyy[, validity extended on dd.mm.yyyy]

IISPECIFIC CONDITIONS OF THE EUROPEAN TECHNICAL APPROVAL

1Definition of product(s) and intended use

1.1Definition of the construction product

24 Official Journal of the European Communities N° L 40, 11.2.1989, p. 12

25 Official Journal of the European Communities N° L 220, 30.8.1993, p. 1

26 Official Journal of the European Union N° L 284, 31.10.2003, p.1

27 Official Journal of the European Communities N° L 17, 20.1.1994, p. 34

ETAG 026

43

Document info
Document views102
Page views102
Page last viewedSun Dec 04 01:06:58 UTC 2016
Pages47
Paragraphs2339
Words16195

Comments