X hits on this document

Word document

DEPARTMENT OF ENVIRONMENTAL PROTECTION - page 13 / 17

31 views

0 shares

0 downloads

0 comments

13 / 17

06-096 – DEPARTMENT OF ENVIRONMENTAL PROTECTION

F.Rust preventive coatings. The labels of all rust preventive coatings shall prominently display the statement “For metal substrates only”.

G.Specialty primers, sealers and undercoaters. The labels of all specialty primers, sealers and undercoaters shall prominently display one or more of the descriptions listed below:

(1)“For blocking stains”.

(2)“For fire-damaged substrates”.

(3)“For smoke-damaged substrates”.

(4)“For water-damaged substrates”.

(5)“For excessively chalky substrates”.

H.Quick dry enamels. The labels of all quick dry enamels shall prominently display the words “Quick dry” and the dry hard time.

I.Non-flat high-gloss coatings. The labels of all non-flat high-gloss coatings shall prominently display the words “High gloss”.

5.Reporting requirements

A.

Each manufacturer of a product subject to a VOC content limit in section 3(A) shall keep records demonstrating compliance with the VOC content limits. Such records shall clearly list each product by name (and identifying number, if applicable) as shown on the product label and in applicable sales and technical literature, the VOC content as determined in section 6(A) and 6(B), the name(s) and chemical abstract service (CAS) number of the VOC constituents in the product, the dates of the VOC content determinations, and the coating category and the applicable VOC content limit. These records shall be kept for a period not less than five years and shall be made available to the Department within 90 days of request.

B.

A responsible official from each manufacturer shall upon request of the commissioner provide data concerning the distribution and sales of coatings subject to a VOC content limit in section 3(A). The responsible official shall within 90 days provide information including, but not limited to:

(1)

the name and mailing address of the manufacturer;

(2)

the name, address and telephone number of a contact person;

(3)

the name of the product as it appears on the label and the coating category in section 3(A) under which it is regulated;

(4)

whether it is marketed for interior or exterior use or both;

(5)

the number of gallons sold in Maine in containers greater than one liter;

Chapter 151: Architectural and Industrial Maintenance Coatings

-13-

Document info
Document views31
Page views31
Page last viewedFri Dec 02 20:37:14 UTC 2016
Pages17
Paragraphs434
Words6434

Comments