X hits on this document

Word document

Every effort has been made to ensure that the information in this document is complete, - page 179 / 249

928 views

0 shares

0 downloads

0 comments

179 / 249

Network Preparation

Ÿ

You must have network administrator privileges to install the OkiLAN 6200e.

Ÿ

You must have physical access to an OS/2 file server to host the OKI software utilities.

Ÿ

Write down the serial number and the Ethernet address of your OkiLAN 6200e.

Ÿ

OS/2 and LAN Manager/LAN Server must be configured with the following protocol: DLC/802.2 protocol stack

Ÿ

LAN Manager users must enable the remote boot facility.

Ÿ

LAN Server 2.X users must run the LAN Server installation utility and select the 802.2 protocol.

Ÿ

LAN Server 3.0 users must run the LAPS utility and select the 802.2 protocol.

Ÿ

OS/2 Warp Users must run the MPTS utility and select the 80w.w protocol. See your network administrator or the LAN Manager/LAN Server manuals for instructions.

Ÿ

The initial installation requires the file server to be brought down and then back up again. This may be a consideration when you are planning your install.

Depending on your current configuration, the following software may also be needed:

Ÿ

Printer driver installation diskettes. These diskettes are provided with the OS/2 operating system or are available from the printer manufacturer.

Ÿ

LAN Manager or LAN Server installation diskettes.

Note: It is strongly recommended that you make backup copies of the OS2.INI and OS2SYS.INI files before you install the OkiLAN 6200e. Follow the directions in your OS/2 documentation to back up these files.

Document info
Document views928
Page views928
Page last viewedTue Dec 06 22:28:16 UTC 2016
Pages249
Paragraphs3453
Words36582

Comments