X hits on this document

Word document

Every effort has been made to ensure that the information in this document is complete, - page 69 / 249

1012 views

0 shares

0 downloads

0 comments

69 / 249

SNMP Traps Configuration

The SNMP Trap option allows configuration of traps. Traps are unsolicited information concerning the OkiLAN 6200e. Traps can be sent to an SNMP manager or be broadcast to all hosts on the local segment.

To configure SNMP traps, select the SNMP Traps file tab. The following screen will display:

Fill in the following information:

Protocol

Select the protocol for which you wish to configure trap information.

Trap Destination

Ÿ

NetWare Protocol - Enter the network number and hardware address, respectively, to which traps will be sent. To broadcast traps to all addresses on all networks, enter FFFFFFFF (8 characters) in the first field and FFFFFFFFFFFF (12 characters) in the second field. To broadcast traps to all addresses on a specific network, enter the network number in the first field and then FFFFFFFFFFFF (12 characters) in the second field.

Ÿ

TCP/IP Protocol - Enter the IP address to which traps will be sent. The IP address must follow the format XXX.XXX.XXX.XXX, where each XXX is a number from 0 to 255. To broadcast traps to all hosts on the local subnet, enter 255.255.255.255.

Ports to Trap

Select the output ports on which you wish traps to be active.

Document info
Document views1012
Page views1012
Page last viewedSun Dec 11 02:20:30 UTC 2016
Pages249
Paragraphs3453
Words36582

Comments