X hits on this document

20 views

0 shares

0 downloads

0 comments

3 / 8

SOFTWARE – EDITING TABLES

Twin Tec PC Link software allows easy editing of all engine control tables. Tables are displayed in industry standard format with 3D graphics and an associated spreadsheet. Editing is very difficult and tedious with the ThunderMax® SmartLink software. For example, if a customer has a high compression engine that exhibits spark knock near wide open throttle in the 2000-3000 RPM range, a few simple mouse clicks suffice to select an RPM and manifold pressure range to edit in the Twin Tec PC Link software. In the ThunderMax® SmartLink software there are four individual tables each with many individual points that must be individually edited. Each point on each table must be selected with the mouse and then keyboard strokes (up or down arrow) are required to change each point.

Figure 3 – Editing Advance Table in PC Link

Daytona Twin Tec LLC, 933 Beville Road, Suite 101-H, S. Daytona, FL 32119 (386) 304-0700 www.daytona-twintec.com Page 3

TCFI III & TMax Comparison 4/2011

Document info
Document views20
Page views20
Page last viewedFri Dec 09 08:27:24 UTC 2016
Pages8
Paragraphs48
Words1782

Comments