X hits on this document

PDF document

Laser Measuring - page 6 / 12

33 views

0 shares

0 downloads

0 comments

6 / 12

MoClamp Laser Measuring System

It is suggested you set the 4 points under the passenger section of the vehicle if possible. Be sure the front two hangers are as close to the same as possible and then attach the rear two. Use either hole, pinch weld or roll pins again, keeping in mind the end result is to have the front and rear centerline bars hanging so the outer support bars will be as level as possible when they tie the centerline bars together.

Hanging the centerline bars from the vertical scales is next. Use the vertical hanger blocks and secure the blocks to the vertical legs. Adjust the top or bottom to the scale so both sides of the vehicle read the same measurements. Use the u-shaped coupler and connect a left and right side so the numbers

read progressively larger centerline out to the ends.

from

Warning: Now is a critical time to place a laser head if you are wanting to shoot a centerline under the vehicle.

Document info
Document views33
Page views33
Page last viewedFri Dec 09 11:48:12 UTC 2016
Pages12
Paragraphs65
Words1527

Comments