X hits on this document

PDF document

Laser Measuring - page 8 / 12

28 views

0 shares

0 downloads

0 comments

8 / 12

MoClamp Laser Measuring System

Setting up the upper body area is a simple process. Begin by adding the two upper body T-blocks at a point on the outer support bars that will allow the centerline bar to be across the upper engine compartment as close to the windshield as possible.

Stand the two 5 foot bars in the T- blocks so the lowest numbers are at the bottom.

As with the lower centerline setup, attach the two centerline bars to the coupler.

Attach the laser and shim to the coupler at the zero point on the centerline bar.

Attach the centerline bar to the vertical bars across the engine compartment and be sure the tape numbers agree on both sides of the vehicle.

Get out the Fast Stick, turn on the laser and measure!

The upper body centerline laser is tied directly with the underbody laser so your coordination of the two areas is made very easy to control in the correction process.

Document info
Document views28
Page views28
Page last viewedSat Dec 03 16:08:30 UTC 2016
Pages12
Paragraphs65
Words1527

Comments