X hits on this document

47 views

0 shares

0 downloads

0 comments

15 / 17

Determining the Unit ID

Each Color Cue®2.1 has a unique 7-character ID. This ID defines the information on the unit configuration, micro code ID, etc. You may need this ID, especially when you contact your dealer or the manufacturer with any questions. To determine the unit ID, turn the power off and back on. The unit ID will appear in the third screen after the unit is turned on. To pause the display, press the menu key as soon as the display appears. Pressing the menu key again will continue the start-up cycle.

Light Source

PANTONE Library Serial Number

Micro-code ID Version Number

Cleaning the Aperture s Measurement Port

There is a recessed clear window inside the port. When the instrument is new, this window is so clear that it is almost invisible. You should always be able to see the sensor (a gray square in the center of a round ring) and the light emitting diodes (rectangular boxes inside the edge). Examine the sample port from the bottom of the instrument to see if there is visible dust or dirt. The instrument’s measurements may be affected if this area contains any foreign materials. Extreme care must be taken not to damage the actual dam (black ring) or the sensor itself. Only the clear window surrounding the opening for the sensor/ring should be cleaned.

Radio and Television Interference

The Color Cue®2.1 has been tested and found to comply within the limits for a digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference. This equipment can radiate radio frequency energy and, if not used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna Increase the distance between the Color Cue®2.1 and the receiver

Changes or modifications not expressly approved by the manufacturer may void the user’s authority to operate this equipment.

Technical Specifications

Measurement time Measurement per battery Stability under test conditions LED Life in normal use Design Color Sensitivity Calibration period Spectral Channels Weight (without battery) Length Width Height Controls Display

Approximately 1/10 second Greater than 10,000 Less than 0.1 in each component of CIELAB Greater than 10 years Greater than 10 million unique colors Weeks to Months Six 3.0 oz 5 in

    • 1.4

      in

    • 2.2

      in

6 buttons 8 lines, 15 characters LCD

PANTONE Color Cue®2.1 User Manual

Page 15 of 17

Document info
Document views47
Page views47
Page last viewedFri Dec 09 16:16:33 UTC 2016
Pages17
Paragraphs428
Words4290

Comments