X hits on this document

PDF document

Specification Approval Sheet - page 10 / 11

29 views

0 shares

0 downloads

0 comments

10 / 11

Soldering temperature should not exceed 350.

    • c.

      Soldering time should not be longer than 3 seconds .

    • d.

      Keep battery tab cold down before next time soldering.

    • e.

      Directly heat cell body is strictly prohibited. Battery should be damaged by heat above approx. 60.

      • 7.3.2

        Cell fixing

The battery should be fixed to the battery pack by its large surface area.

No sharp edge at the assembling position. No cell movement in the battery pack should be allowed. 8.Others

8.1 The disassembling may generate internal shout circuit in the cell, which

may cause gassing, firing, or other problem. 8.2 Prohibition of dumping of cells into fire

N e v e r i n c i n e r a t e o r d i s p o s e t h e c e l l s i n f i r e , f o r t h e s e m a y c a u s e f i r i n g o f the cells. 8.3 The cells should never be soaked with liquids such as water, drinks or oil.

8.4 Prohibit using the cells mixed with different manufactories. Prohibit using

new cells mixed with old ones.

  • Special Notice: Keep the

cells

in

half-charged

state,

which

is

keeping them fully charged or completely discharged. Storing the cells in cool and dry place.

PDF created with pdfFactory trial version www.pdffactory.com

Document info
Document views29
Page views29
Page last viewedMon Dec 05 20:39:55 UTC 2016
Pages11
Paragraphs522
Words2252

Comments