X hits on this document

PDF document

Specification Approval Sheet - page 8 / 11

27 views

0 shares

0 downloads

0 comments

8 / 11

2. Discharging Current: The cell shall be discharged at less than the maximum discharge current specified in the Specification Approval Sheet. High discharging current may reduce the discharging capacity significantly or cause over-heat.

3. Discharging Temperature

Discharging in this

Temperature

should

be

within

the

range

specified

Specification Approval Sheet.

4.Over-Discharge

Over-discharging will cause cell low-performance and function loss. The cell

would be characteristic.

in a over-discharged state by its In order to prevent over-discharging, the

self-discharge cell shall be

charged

periodically

to maintain between 3.6V and 3.9V.

  • 5.

    Protective Circuit Module

    • 5.1

      The cell / battery pack shall be with a PCM that can protect cell / battery

pack properly. PCM shall have functions of

  • (1)

    Overcharging prevention

  • (2)

    Over-discharging prevention

(3)

Over

current

prevention

significant deterioration

of

to

maintain

safety

cell

performance.

and

prevent

The

over

current

can

occur

by external short circuit.

5.2 Overcharging Protection Overcharging prevention function of the battery pack reaches 4.30V.

shall

stop

charging

if

any

cell

5.3 Over-discharging protection Over-discharging protection function shall monitor the voltage of every cell in the pack, and work to avoid further drop in the cell voltage of 2.5V or less.

6. Storage Cells should Specification Approval Sheet.

be

stored

in

proper

temperature

specified

in

7.

Notice!7.1 Handling of cells:

Avoid

any

short-circuit,

it

will

caused

the

pole

hot

and

lost

electronic functions.

PDF created with pdfFactory trial version www.pdffactory.com

Document info
Document views27
Page views27
Page last viewedMon Dec 05 17:29:23 UTC 2016
Pages11
Paragraphs522
Words2252

Comments