X hits on this document

PDF document

Specification Approval Sheet - page 9 / 11

26 views

0 shares

0 downloads

0 comments

9 / 11

Don’t use the charger without any safety guarantee, and recommend you use specified charger.

You should immediately stop charging, as cell is overheating, delivery any smell, changed color, distortion etc.

Before Children use batteries, adults should explain the usage first. Before use batteries, please read the handling guideline carefully and

fully understand. Away from the static-electronic field, while using, charging and storing

voltage container.

as

barrette, bolt into the pocket or stored them together.

Soft packing is very damaged by sharp edge parts such as needles and

Beside the poles is the sealed edge. Don’t bend or fold dealing edge, for it is a sensitive part. Don’t open the folding edge on both sides of the cells. Don’t bend the tabs, for the tabs are not so stubborn. Avoid mechanical shock to the cells. Don’t put the cells into the heater, washing machine or high-

such

part, when

conductors

Don’t use metal conductor to shortcut the positive and negative poles. Don’t mis-assemble the positive pole with the negative one.

be

edge

metal

should

knives. Avoid cells touch with handling and storage.

sharp

together with

battery

cells. Don’t chains,

put the cells

and

strength

7.2 Notice for Designing Battery Pack

sufficient

7.2.1 Package Design

Battery

pack

should

have

protected from mechanical shock. No sharp edge components should be inside the pack containing the

battery. 7.2.2PCM Design

The 4.30V

overcharge

threshold

voltage

should

not

be

exceed

(single pack) The over-discharge threshold voltage should not be lower than 2.50V

(single pack) The PCM should have short protection built inside.

7.3 Notice for Assembling Battery Pack

7.3.1 Tab connection

Ultrasonic

welding

or

spot

welding

is

recommended

to

connect battery with PCM or other parts.

If apply manual solder method to connect tab with PCM, below notice is very important to ensure battery performance. a. The solder iron should be temperature controlled and ESD safe. b.

PDF created with pdfFactory trial version www.pdffactory.com

Document info
Document views26
Page views26
Page last viewedMon Dec 05 14:55:42 UTC 2016
Pages11
Paragraphs522
Words2252

Comments