X hits on this document

134 views

0 shares

0 downloads

0 comments

25 / 50

Table of Contents

Section 6: Maintenance

Engine Torques For engine torque values, see engine owner’s manual.

All Other Torques

For all other torques refer to “Torque Values Chart” page 45.

Tire Maintenance

  • 6.

    Work may now be performed on the vehicle. Be sure to properly torque all bolts that were loosened. Wheel bolts should be torqued after the vehicle is lowered to the ground.

  • 7.

    Lower the vehicle by first jacking the vehicle up high enough to remove the jack stands. Then carefully lower the jack until the vehicle is on the ground.

  • 8.

    Remove wheel chocks.

Use only tires recommended by Land Pride.

It is important for your safety and the safety of others that the tires have correct air pressure. Check air pressure in all four tires before each use. Visually inspect tires for loss of air throughout each day of operation. See Tire Inflation Chart below for correct tire pressure.

Tire Inflation Chart

Inflation PSI

Front Tires

15*

Rear Tires

20*

Tire

*Maximum tire pressure is noted on tire side wall.

Figure 6-1

21350

Jacking the Vehicle

!

DANGER

For your safety and safety of others, a jacked vehicle must be supported properly with jack stands before working under and around it. Also the wheels on the ground must be chocked on both sides to prevent the vehicle from rolling forward or backward.

IMPORTANT: Use a hydraulic jack, floor jack, or scissor type jack to lift vehicle. Do not use a handyman jack or bumper jack and don’t jack against the bumper, body, differential case, axles or hydraulic lines.

  • 1.

    Prepare vehicle for maintenance as outlined in steps 1-6 on page 22.

  • 2.

    Loosen the lug nuts on a wheel being removed approximately 1/2 turn counterclockwise while it is still on the ground.

  • 3.

    See important note above. Place proper jack under vehicle as follows:

    • a.

      Front tires: Refer to Figure 6-1. Place jack under the main frame just behind the axle.

    • b.

      Rear tires: Refer to Figure 6-2. Place jack under the main frame just in front of the axle.

  • 4.

    Jack vehicle only high enough to do the work intended.

  • 5.

    Support vehicle securely with jack stands before working under and around the vehicle.

21351

Figure 6-2

Shock Absorbers

Shock absorbers are located under the seat to make the ride more comfortable. Traveling fast may cause the shock absorbers to bottom-out making the ride rough.

Electrical System

A 12 volt, 25 amp, negative ground electrical system is provided. The electrical system is protected by a fuse located behind the dash near the key switch and a moisture proof self-resetting circuit breaker in the wiring harness near the starter at the engine. The amp ratings are as follows:

  • Fuse behind the dash - 30 Amps

  • Self-resetting circuit breaker - 30 Amps

7/14/08

4400EX Heavy Duty Off Road Utility Vehicle 720-051M

23

Document info
Document views134
Page views134
Page last viewedTue Jan 17 13:41:30 UTC 2017
Pages50
Paragraphs2438
Words24423

Comments