X hits on this document

119 views

0 shares

0 downloads

0 comments

29 / 50

Table of Contents

Section 6: Maintenance

High Altitude Carburetor Kit

IMPORTANT: The air-fuel mixture in carburetors modified for high elevation is too lean when operating at elevations below 5,000 feet. Operating engines with modified carburetors below 5,000 feet can result in engine overheating and serious engine damage. Return carburetor to original factory specifications when operating at low elevations.

Power Steering Shield

Gondo vehicles shipped from the factory are equipped with carburetors designed to operate efficiently between 0 and 4,999 feet. Carburetor change over kits for different altitudes may be purchased from your nearest Land Pride Dealer. The following kits are available:

Elevation

Carburetor Kit No.

0’ - 7,999’ 8,000’ & up

Engine Standard 24755125-S

21346

Figure 6-5

Refer to Figure 6-5 5. Remove bolts securing belt cover and remove cover.

Power Steering Belt

Refer to Figure 6-5 & Figure 6-6

Power steering belt and pump are positioned behind the engine and are protected by a shield. Do not remove shield except to service the belt and always replace shield after servicing the belt.

Drive Pulley

Take-up Bolt & Slot

Replace power steering belt when it shows signs of severe cuts, tears, excessive weather checking and cracking or burns caused by slipping. Slight raveling of belt covering does not indicate failure. Trim ravelings with a sharp knife.

Power Steering Pump

Driven Pulley

Inspect belt pulley grooves and flanges for wear. A new belt, or one in good condition, should never run against bottom of pulley groove. Replace pulley when this is the case, otherwise belt will lose power and slip excessively.

Never pry a belt to get it on a pulley as this will cut or damage the fibers of the belt covering.

Keep oil and grease away from belts and never use belt dressings. Any of these will destroy the belt composition in a very short time.

! CAUTION

Make certain to keep fingers from getting caught between belt and pulley when rotating belt over pulley.

Replace power steering belt as follows:

  • 1.

    Prepare vehicle for maintenance as outlined in steps 1-6 on page 22.

  • 2.

    Safely secure the seat console in the raised position.

  • 3.

    Disconnect negative battery cable.

  • 4.

    Safely secure cargo box and seat console in the up position to prevent injury.

21353

Figure 6-6

Refer to Figure 6-6

  • 6.

    Loosen belt take-up bolt and hand squeeze belt together. This should allow room to remove the belt.

  • 7.

    Remove belt by rolling it off over the drive pulley and then lifting it up off the driven pulley.

  • 8.

    Reinstall new belt by placing it over the driven pulley and then rolling it over the drive pulley.

  • 9.

    Re-tension power steering belt and tighten take-up bolt.

  • 10.

    Reinstall belt cover and fasteners.

  • 11.

    Reconnect battery negative cable.

  • 12.

    Remove blocks securing cargo box up and lower cargo box.

7/14/08

4400EX Heavy Duty Off Road Utility Vehicle 720-051M

27

Document info
Document views119
Page views119
Page last viewedSat Dec 10 21:01:05 UTC 2016
Pages50
Paragraphs2438
Words24423

Comments