X hits on this document





36 / 50

Table of Contents

Section 7: Lubrication and Fluids

Transmission Fluid

Transmission lubrication is essential and must be maintained to ensure long life of the transmission. It is extremely important to use proper fluid. Also, it is important to check and change oil as outlined in the maintenance schedule below.

NOTE: Running vehicle low on transmission oil can damage transmission and void its warranty.

Transmission Maintenance Schedule

  • Check case housing for damage and possible fluid leakage after each use.

  • Check fluid level every 6 months or every 100 hours (whichever comes first).

  • Change fluid once every 4 years or every 400 hours (whichever comes first).

Transmission Fluid Type and Capacity See also "Section 10: Specifications and Capacities" on page 40.

  • Type of Fluid: Dextron 3 automatic transmission fluid

  • Fluid capacity: 2 quarts or fill to bottom of fill plug.

Transmission Oil Level Check Refer to Figure 7-8


Check transmission oil level at fill plug (See Figure 7-8) as follows:

  • 1.

    Prepare vehicle for maintenance as outlined in steps 1-6 on page 22.

  • 2.

    Remove fill plug and verify oil is level with bottom of fill hole.

  • 3.

    Add new fluid at the check hole if fluid level is low.

  • 4.

    Replace fill plug and tighten securely.

Transmission Plug

Transmission Fluid Change

Not Required unless water gets in the fluid

The transmission fluid needs to be changed only if water gets into it. Drain transmission fluid by siphoning the fluid out through the fill hole or remove transmission from the vehicle to drain the fluid out through the fill hole.

Brake Fluid

For your safety and the safety of others it is important that the master cylinder fluid be maintained. Have a Land Pride Service Technician inspect the vehicle if the master cylinder is loosing fluid frequently.

Brake Fluid Maintenance Schedule

  • Check fluid reservoir monthly.

  • Fill reservoir immediately if low or if braking capabilities

begin to fade.

Brake Fluid Type and Capacity See also "Section 10: Specifications and Capacities" on page 40

  • Type of fluid: DOT 3

  • Quantity: Fill to within 1/2” of reservoir opening.

Brake Fluid Level Check Refer to Figure 7-9


The master cylinder fluid reservoir is located just above the foot pedals. Remove filler cap and visually inspect level of fluid inside the reservoir. Add DOT 3 fluid to the reservoir until filled to within 1/2” of reservoir opening.

Fill Cap


Engine Muffler



Figure 7-8

Figure 7-9


4400EX Heavy Duty Off Road Utility Vehicle 720-051M


Document info
Document views128
Page views128
Page last viewedMon Jan 16 13:11:17 UTC 2017