X hits on this document





3 / 62


Physical Interfaces

Ethernet Port (LAN)

DC Power Connector

USB Port

Reset Button

WPS Button

USB Port

The DPR-1040’s USB port is located on the rear panel. The port can be configured using the web configurator which allows users to configure settings through their web browser.

The default IP address of the DPR-1040 is automatically acquired from a DHCP server on the network. If a DHCP server cannot be found the default IP address for the DPR-1040 will be

NOTE : The PC’s IP address must be in the same subnet as the Print Server’s IP address for the two devices to communicate. (For example, if the Print server’s IP address is, with a subnet mask of, then your computer’s IP address should be 192.168.0.x, where x is a value between 1-254, excluding 10.)

Ethernet Port (LAN)

The Print Server’s rear panel features an RJ-45 port for the connection of a 10/100Mbps CAT 5 Ethernet cable. The port supports the NWay protocol, allowing the Print Server to automatically detect or negotiate the transmission speed of the network.

DC Power Connector

The DC power input connector is located on the Print Server’s rear panel and is labeled DC 5V.

Wi-Fi Protected Setup (WPS) Button

Press this button to use WPS to easily connect to a wireless network. For more information about this button, see Section 5 - Wireless Setup.

Reset Button (Bottom Panel)

Press and release this button to reset the MFP Server. To restore the device to factory default settings , press and hold the button for three seconds until the USB LED on the front panel lights up and then release the button.


Document info
Document views193
Page views193
Page last viewedSat Oct 22 21:46:48 UTC 2016