X hits on this document

295 views

0 shares

0 downloads

0 comments

5 / 62

HARDWARE INSTALLATION

WARNING: There may be configuration problems if the Print Server is turned on without first establishing a network connection.

Follow the steps below to avoid any complications during the hardware installation:

  • 1.

    Confirm that the printer you will use to connect to the DPR-1040 is operating correctly.

  • 2.

    When you have confirmed that the printer is operating correctly, switch its power OFF.

  • 3.

    Confirm that your network is operating normally.

  • 4.

    Using a CAT 5 Ethernet cable, connect the DPR-1040 Ethernet Port (labeled LAN)

to the network.

5. While the printer is turned OFF, connect the USB printer cable to the printer and then to the USB port on the Print Server.

  • 6.

    Switch on the printer.

  • 7.

    Insert the power adapter’s output plug into the DC 5V power socket on the rear panel

of the Print Server.

8. Connect the other end of the power adapter into a power outlet. This will supply power to the Print Server. The blue LED on the Print Server’s front panel should turn on.

5

Document info
Document views295
Page views295
Page last viewedSun Dec 11 06:43:11 UTC 2016
Pages62
Paragraphs808
Words7732

Comments