X hits on this document

120 views

0 shares

0 downloads

0 comments

17 / 61

Mono-to-Stereo and Stereo

Mono-to-Stereo

Stereo

The Mono-to-Stereo and Stereo Amps share the same controls and graphic user interface, but their input and processing specifications are different.

Mono-to-Stereo is very similar to the Mono DualCab component, but outputs a Stereo signal. So, rather than adding each cabinet’s output to a single path you can flexibly pan them to create a Stereo image from the Mono input.

The Stereo Amp component is actually a dual-Mono configuration. It takes a Stereo input and outputs Stereo. The left input goes through the Amp type to cabinet 1 and the Right Input goes to cabinet 2. Its Pan control can be used to limit the Stereo image width, collapse the Stereo input to a Mono output, or swap the channel outputs by hard panning them in opposite directions.

Waves Guitar Tool Rack User Guide.

17

Document info
Document views120
Page views120
Page last viewedSat Dec 03 10:07:34 UTC 2016
Pages61
Paragraphs556
Words12847

Comments