Designed in accordance with the German VDMA/VDI regulations, the electrical control system is installed in a control cubicle. All switching gears required for open- and closed-loop control and fusing of the units installed are included. The lead to the control cubicle is mounted in the factory.
The setpoint (feed rate in t/hr) is entered on the central control panel. All other units are controlled or switched as a function of the set feed rate. Upon start of the system, a sound signal is produced before the blower or rotary feeder starts operating.
The fill degree of the docking stations is monitored electronically and cyclically starts the hydraulics of the walking floor system on the semitrailer to be loaded.
The weighfeeder is equipped with a DISOCONT weighing electronics complete with additional instrumentation section for commissioning, evaluation and monitoring.
Information on actual value, daily totals, etc. can be called up. Interfacing with a host system is also possible.
A PLC system monitors and controls all system components. This enables the individual system to operate in automatic mode so that no manual operator interventions are required.
The system control is equipped with a power switch.
In case of emergencies, the complete system can be shut down with the use of Emergency Stop switches aborting the entire conveying function and immediately closing the rotary closure on the kiln.
Measuring and Process Systems SCHENCK PROCESS GmbH D-64273 Darmstadt
+49 (0) 61 51-32 10 28
+49 (0) 61 51-32 11 72
E-Mail: firstname.lastname@example.org www.schenck-process.net
Steel plate control cubicle, two-wing type
Designed in accordance with VDMA/VDI
Surface powder-coated to RAL 7032
PLC control (SIEMENS S7)
Fieldbus for serial data exchange
Control cubicle dimensions:
approx. 1,200 mm approx. 500 mm approx. 2,000 mm
Coupling to host system
Additional queries and evaluations
Top coat in other RAL shades
A cooperation between SCHENCK PROCESS GmbH and Energieberatung Hess GmbH
BV-D2145GB XBS 05.0901. We reserve the right to discontinue or change specifications or designs at any time without notice or obligation.