X hits on this document

267 views

0 shares

1 downloads

0 comments

1 / 88

1 MAXDVR & DR Series Cards

Please Note: This DVR software is for use with the 4 Channel USB DVR and also specific 1, 4, 8 and 16 channel DVR Cards. Not all software functions discussed below are available, applicable or supported by all hardware.

The following are standard functions of the products: (1) Schedule record mode Users can choose any term in a day to record and set up record modes, i.e. sensor alarm record, motion detection record, manual record, Schedule Record.

(2) Motion detection mode Motion detection areas are adjustable and maximum 16 areas for each channel. Users can also set motion detection sensitivity for each channel. The system begins to record only when motion of the detected object happens, and it will stop recording after a certain period, this function is adjustable by users.

(3) Sensor alarm record mode With extra alarm board, the system enables alarm input and output. (4) Recycling record mode Users can set recording storage sequence for HDD partitions. The recording storage will automatically swap to the next partition when it is full. If all the partitions are full and recycling record mode is enabled, the former recorded data will be covered by new data. Users can also set HDD minimum storage alarm. Then once the present storage space is less then the minimum storage and recycling record mode is not enabled, the record will automatically stop.

(5) P.T.Z control function Support a number of decoders. Users can control multiple speed domes and integrative cameras, including pan, tilt, zoom, focus and iris adjustment for P.T.Z devices. Support preset point and auto scout. (6) Users management

Document info
Document views267
Page views323
Page last viewedSat Dec 03 10:27:08 UTC 2016
Pages88
Paragraphs963
Words9047

Comments