2005-2009 Ford Mustang 4.6L 3-Valve
Re-install the smaller diameter coolant
pipe by first carefully starting the end on the engine block nipple. Secure the coolant pipe
with the bolt previously removed. Re-connect the ECT and EKS sensor connectors. Using some of the ty-straps supplied, secure the connectors to the coolant pipe and the remaining portion of the
Engine Block Nipple
Re-install the coolant hose onto the pipe
using the original clamp.
On to the remaining coolant hose, install
the 90-degree connector and the “elbow” hose supplied as shown. Secure the 90-degree fitting with the original clamp, and the elbow hose with
the new spring clamp supplied.
Here is the 90-degree fitting and elbow
hose installed. Route the long straight section of the elbow hose forward along the side of the
engine to be connected in a later step.