2005-2009 Ford Mustang 4.6L 3-Valve
Install the coolant hose on the thermostat
hose barb using the supplied worm gear clamp. Rotate the clamp down to the driver side of the
hose for clearance with the throttle body to be installed later.
Install the end of the elbow hose on to the
barb of the new coolant hose connector with the spring clamp supplied. Position the connector and elbow hose so that the elbow hose can be routed beside the engine. Tighten the connector hose clamps. Refill the radiator reservoir with the
Hose Connector Barb
coolant removed earlier.
Here is the new drive belt idler pulley and
Idler Pulley Mounts Here
Spacer Idler Pulley Bolt
Install the new bolts through the bracket
and into the holes that originally mounted the al- ternator. Note, the gap between the bracket and the block, this is where the alternator will mount.