2005-2009 Ford Mustang 4.6L 3-Valve
Install the alternator and torque the two
mounting bolts to 22 ft-lbs (30 Nm) using a 12mm
socket and torque wrench.
Install the idler pulley with its spacer into
the remaining hole on the mounting bracket with the bolt supplied. Torque this bolt to 28 ft-lbs (38
Nm) using a 15mm socket and torque wrench.
Install the two supplied alternator support
brackets using the four supplied 6mm x 16mm bolts. The short bracket goes on the driver side. Torque to 106” lbs using a 10mm socket, be sure
to verify your torque wrench settings.
Remove the three bolts that secure the
belt tensioner using a 10mm socket wrench and remove the tensioner from the front of the motor.