X hits on this document

PDF document

INTERCOOLED SUPERCHARGER SYSTEM 2005-2009 FORD MUSTANG 4.6L 3V - page 26 / 60

276 views

0 shares

0 downloads

0 comments

26 / 60

2005-2009 Ford Mustang 4.6L 3-Valve

92.

Install the crimp/shrink connectors by strip-

ping a 3/8” of insulation off each end of the wires. Insert one end of the wire into the crimp shrink connector and crimp it securely. Using a heat gun or blow dryer set on high; shrink the plastic covering of the connector until the plastic cover- ing completely around the wire. Crimping the connector alone is not enough to ensure a per- manent connection; you must shrink the plastic covering! When you are finished cover the wires

and connectors with the piece of split loom sup- plied.

93.

Install the new IAT sensor connector onto

the IAT sensor located at the rear of the super-

Intake Air Temperature Sensor

charger manifold.

94. body.

Install the ETC connector onto the throttle

95.

The Throttle Position Sensor connection

must be extended to reach the new Throttle Body

location. Here are the Throttle Position Sensor wire extension components.

03/10

Page 26

www.magnacharger.com

Document info
Document views276
Page views276
Page last viewedWed Jan 18 04:06:54 UTC 2017
Pages60
Paragraphs1328
Words7896

Comments