2005-2009 Ford Mustang 4.6L 3-Valve
Strip off about 3/8” of insulation off all the
ends of the supplied wires, and use the supplied crimp/shrink connectors to crimp onto each ex-
Cut the existing Throttle Position Sensor
wires about 2” from the connector. Color-match
the wires you just prepared to the existing Throt- tle Position Sensor plug wires, and crimp the wire
extensions between the cut ends of the OEM Throttle Position Sensor…extending the plug.
Shrink all of your connections using a heat
gun, or a hair dryer set on high. It is not sufficient
to just crimp the wires together, you must shrink the connectors as well to ensure a complete connection and maintain moisture barrier. After all connections are secured, cover the extended wires with the provided split-loom and tape the junctions.
Plug the extended Throttle Position Sensor
into the Throttle body connection.