2005-2009 Ford Mustang 4.6L 3-Valve
Carefully remove the MAF element from
the air box cover by removing the two screws us-
ing a T-20 Torque driver.
Assemble the MAF element into the new
air box cover with the original screws.
direction of the “FLOW” as shown on the MAF el- ement-mounting flange, this should point towards
the round opening of the new air box cover.
Here are the new air box cover latch com-
ponents. There are components for three latch assemblies.
Install the air box cover latches by sliding
the base plate into place on the left (inlet) side
of the air box.
Push the base plate up under the
upper edge of the box and against the side of the
air box mount.
Note how the left side of the base
plate matches the contour of the air box. Use a scribe or a pen to mark the location of the holes in the base plate on the side of the air box.
Push Up and Over, Mark Position