X hits on this document

PDF document

INTERCOOLED SUPERCHARGER SYSTEM 2005-2009 FORD MUSTANG 4.6L 3V - page 50 / 60

167 views

0 shares

0 downloads

0 comments

50 / 60

2005-2009 Ford Mustang 4.6L 3-Valve

188.

Here is the intercooler bracket and pump-

mounted in position on the exposed ends of the two new bumper bolts previously installed. Use the two 8mm nuts shown in the previous step to

mount the bracket to the bumper bolts. Tighten the nuts securely using a 12mm wrench.

189.

Route the Red and Black wires with the

pump electrical connector from the pump relay

forward to the intercooler pump. nector into the end of the pump.

Plug the con-

190.

Here is the Intercooler heat exchanger and

this is the position it will mount on the vehicle. Note: The hose connections are on the bottom and the vent port on the top

191.

Locate the vent port fitting supplied. Apply

some Teflon pipe tape or “dope” to the threaded end of the fitting.

03/10

Page 50

Pump Electrical Connector

Vent Port

Hose Connections

www.magnacharger.com

Document info
Document views167
Page views167
Page last viewedWed Dec 07 16:30:16 UTC 2016
Pages60
Paragraphs1328
Words7896

Comments