X hits on this document

PDF document

INTERCOOLED SUPERCHARGER SYSTEM 2005-2009 FORD MUSTANG 4.6L 3V - page 51 / 60

160 views

0 shares

0 downloads

0 comments

51 / 60

2005-2009 Ford Mustang 4.6L 3-Valve

192.

Carefully install the fitting securely into the

vent port on the top of the heat exchanger using an 11mm wrench. Do not over tighten!

193.

Remove the power steering cooler mount-

ing bracket bolts using a 10mm socket wrench. Allow the power steering cooler to carefully hang out of the way as you position the intercooler heat

exchanger.

Remove These Bolts

194.

The intercooler heat exchanger will mount

in front the air conditioning condenser and behind

the power steering cooler.

195.

Starting on the passenger side location

where the power steering cooler bracket mount- ed, replace the power steering cooler mounting bolt with the longer bolt and spacer supplied. Pass the bolt through the power steering mount- ing bracket, then the intercooler heat exchanger bracket, next the tubular spacer supplied and finally into the original hole. Do not completely tighten the bolt at this time, leave them finger tight until all four fastener of the heat exchanger

P/S Cooler Bracket

Spacer

are in place.

03/10

Page 51

New Bolt

Intercooler Bracket

www.magnacharger.com

Document info
Document views160
Page views160
Page last viewedMon Dec 05 16:42:57 UTC 2016
Pages60
Paragraphs1328
Words7896

Comments