X hits on this document

PDF document

INTERCOOLED SUPERCHARGER SYSTEM 2005-2009 FORD MUSTANG 4.6L 3V - page 52 / 60

284 views

0 shares

0 downloads

0 comments

52 / 60

2005-2009 Ford Mustang 4.6L 3-Valve

196.

On the driver side power steering cooler

bracket location, replace the power steering cooler mounting bolt with the longer bolt and

spacer supplied.

Pass the bolt through the power

steering mounting bracket, then the intercooler heat exchanger bracket, next the tubular spacer supplied and finally into the original hole. Do not completely tighten the bolts at this time, leave them finger tight until all four fastener of the heat exchanger are in place.

197.

On the upper right front face of the air con-

ditioner condenser, locate the small bolt shown and remove it using an 8mm socket wrench.

Remove This Bolt

198.

Position the heat exchanger mounting

bracket over the bolt hole and pass the original

bolt through the bracket and into the original hole.

Tighten the bolt securely using a 8mm socket wrench.

199.

Note that the heat exchanger mounting

bracket aligns over a small bolt hole in the air

conditioner condenser.

03/10

Page 52

Screw Location

www.magnacharger.com

Document info
Document views284
Page views284
Page last viewedWed Jan 18 21:12:30 UTC 2017
Pages60
Paragraphs1328
Words7896

Comments