X hits on this document

PDF document

Epoxy300MSDS.pdf - page 4 / 5

27 views

0 shares

0 downloads

0 comments

4 / 5

===============================================================

SECTION VII -SPILL OR LEAK PROCEDURES

  • -

    STEPS TO BE TAKEN IN CASE MATERIAL IS RELEASED OR SPILLED:

Ventilate area. Absorb spill with suitable absorbent material and place into a closed container. For large spills, dike area and pumpinto closed containers. Prevent this material from entering waterways. Wear protective equipment during cleanup.

  • -

    WASTE DISPOSAL METHOD:

At this time, this material or its containers would not beconsidered hazardous wastes as defined under the federal RCRA regulations(40 CFR 261) if discarded. Care should be taken to ensure thatthe material or its containers are disposed of in an approvedfacility inaccordance with current federal, state, and local regulations.

For further information, contact your state or local waste agencyor the United States Environmental Protection Agency's RCRA hotline(800-424-9346 or 202-382-3000).

===============================================================

SECTION VIII -SPECIAL PROTECTION INFORMATION

  • -

    RESPIRATORY PROTECTION: Should be worn to avoid breathing spray mist,

heated vapors or if TLV is exceeded.

  • -

    VENTILATION: Local exhaust and general ventilation recommended.

  • -

    PROTECTIVE GLOVES: Chemical-resistant plastic or rubber.

  • -

    EYE PROTECTION: Chemical goggles.

  • -

    OTHER PROTECTIVE EQUIPMENT: As required to prevent wetting skin orclothing.

===============================================================

Document info
Document views27
Page views27
Page last viewedThu Oct 27 05:54:45 UTC 2016
Pages5
Paragraphs100
Words666

Comments