X hits on this document

571 views

0 shares

0 downloads

0 comments

25 / 150

PROPOSED RULES

shall be recorded and reported in accordance with the provisions of Paragraph (f) of this Rule.

(e)  Test Methods and Procedures.
(1)The test methods and procedures described in 15A NCAC 02D .0501 and in Parts (A) through (K) of this Subparagraph shall be used to show compliance:

(A)40 CFR 60.58b(b) for continuous emissions monitoring of oxygen or carbon monoxide at each location where carbon monoxide, sulfur dioxide, or nitrogen oxides are monitored;

(B)40 CFR 60.58b(c) for determination of compliance with particulate emission limits;

(C)40 CFR 60.58b(d) for determination of compliance with emission limits for cadmium, lead and mercury;

(D)40 CFR 60.58b(e) for determination of compliance with sulfur dioxide emission limits from continuous emissions monitoring data;

(E)40 CFR 60.58b(f) for determination of compliance with hydrogen chloride emission limits;

(F)40 CFR 60.58b(g) for determination of compliance with dioxin/furan emission limits;

(G)40 CFR 60.58b(h) for determination of compliance with nitrogen oxides limits from continuous emission monitoring data;

(H)40 CFR 60.58b(i) for determination of compliance with operating requirements under Paragraph (d) of this Rule;

(I)40 CFR 60.58b(j) for determination of municipal waste combustor unit capacity;

(J)40 CFR 60.58b(k) for determination of compliance with the fugitive ash emission limit; and

(K)40 CFR 60.58b(m)(1) to determine parametric monitoring for carbon injection control systems.

(2)Rule .0501 of this Subchapter and in Method 29 of 40 CFR Part 60 Appendix A8 A and 40 CFR Part 61 Appendix B shall be used to determine compliance with emission rates. Method 29 of 40 CFR Part 60 shall be used to determine emission rates for metals. However, Method 29 shall be used only to collect sample for chromium (VI), and SW 846 Method 0060 shall be used for the analysis.
(3)The owner or operator will conduct initial and annual stack tests to measure the emission levels of dioxins and furans, cadmium, lead,
mercury, beryllium, arsenic, chromium (VI), particulate matter, opacity, hydrogen chloride, and fugitive ash. Annual stack tests for the same pollutants will be conducted no later than 12 months after the previous stack test.
(2)The owner or operator of a large municipal waste combustor shall do compliance and performance testing according to 40 CFR 60.58b.
(3)For large municipal waste combustors that achieve a dioxin and furan emission level less than or equal to 15 nanograms per dry standard cubic meter total mass, corrected to seven percent oxygen, the performance testing shall be performed according to the testing schedule specified in 40 CFR 60.58b(g)(5)(iii).
For class I municipal waste combustors the performance testing shall be performed according to the testing schedule specified in 40 CFR  60.1785 to demonstrate compliance with the applicable emission standards in Paragraph (c) of this Rule.
(4)The testing frequency for dioxin and furan may be reduced if the conditions under 40 CFR 60.58b(g)(5)(iii) are met and the owner or operator notifies the Director of the intent to begin the reduced dioxin and furan performance testing schedule during the following calendar year.
(5)The owner or operator of an affected facility may request that compliance with the dioxin and furan emission limit be determined using carbon dioxide measurements corrected to an equivalent of seven percent oxygen. The relationship between oxygen and carbon dioxide levels for the affected facility shall be established as specified in 40 CFR 60.58b(b)(6).
(6)(4)The Director may require the owner or operator of any incinerator subject to this Rule to test his incinerator to demonstrate compliance with the emission standards in Paragraph (c) of this Rule.
(f)  Monitoring, Recordkeeping, and Reporting.
(1)The owner or operator of an incinerator subject to the requirements of this Rule a municipal waste combustor shall comply with the monitoring, recordkeeping, and reporting requirements established pursuant to Section .0600 of this Subchapter.
(2)The owner or operator of an incinerator a municipal waste combustor that has installed air pollution abatement equipment to reduce emissions of hydrogen chloride shall install, operate, and maintain continuous monitoring equipment to measure pH for wet scrubber systems and rate of alkaline injection for dry scrubber systems.

22:23                                                               NORTH CAROLINA REGISTER                                           JUNE 2, 2008

2091

Document info
Document views571
Page views571
Page last viewedMon Dec 05 09:57:40 UTC 2016
Pages150
Paragraphs7104
Words102637

Comments