X hits on this document

569 views

0 shares

0 downloads

0 comments

29 / 150

PROPOSED RULES

where Rule .0524, .1110, or .1111 of this Subchapter applies. However, when Subparagraphs (13) or (14) of this Paragraph and Rule .0524, .1110, or .1111 of this Subchapter regulate the same pollutant, the more restrictive provision for each pollutant shall apply, notwithstanding provisions of Rules .0524, .1110, or .1111 of this Subchapter to the contrary.
(2)Particulate Matter. Emissions of particulate matter from each municipal waste combustor shall not exceed 27 milligrams per dry standard cubic meter corrected to seven percent oxygen.
(3)Visible Emissions. The emission limit for opacity from each class I municipal waste combustor shall not exceed 10 percent (average of 30 six-minute averages).
(4)Sulfur Dioxide. Emissions of sulfur dioxide from each class I municipal waste combustor shall not exceed 31 parts per million by volume, dry basis, or potential sulfur dioxide emissions shall be reduced by at least 75 percent volume, dry basis. Percent reduction shall be determined from continuous emissions monitoring data and in accordance with reference method 19, Section 12.5.4 of 40 CFR Part 60, Appendix A-7. Compliance with either standard is based on a 24-hour daily block geometric average of concentration data corrected to seven percent oxygen.
(5)Nitrogen Oxide. Emissions of nitrogen oxide from each class I municipal waste combustor shall not exceed the emission limits in Table 3 of 40 CFR Part 60, Subpart BBBB.
(6)Odorous Emissions. Any incinerator subject to this Rule shall comply with Rule .1806 of this Subchapter for the control of odorous emissions.
(7)Hydrogen Chloride. Emissions of hydrogen chloride from each class I municipal waste combustor shall not exceed 31 milligrams per dry standard cubic meter (31 parts per million by weight as determined by reference method 26 or 26A of 40 CFR Part 60, Appendix A-8) or potential hydrogen chloride emissions shall be reduced by at least 95 percent of the mass concentration, dry basis. Compliance with this Part shall be determined by averaging emissions over three one-hour test runs, with paired data sets for percent reduction and correction to seven percent oxygen.
(8)Mercury Emissions. Emissions of mercury from each municipal waste combustor shall not exceed 0.080 milligrams per dry standard cubic meter (as determined by reference method 29 of 40 CFR Part 60, Appendix A-8) or potential mercury emissions shall be
reduced by at least 85 percent of the mass concentration, dry basis. Compliance with this Part shall be determined by averaging emissions over three one-hour test runs, with paired data sets for percent reduction and correction to seven percent oxygen.
(9)Lead Emissions. Emissions of lead from each class I municipal waste combustor shall not exceed 0.490 milligrams per dry standard cubic meter and corrected to seven percent oxygen (as determined by reference method 29 of 40 CFR Part 60, Appendix A-8).
(10)Cadmium Emissions. Emissions of cadmium from each municipal waste combustor shall not exceed 0.040 milligrams per dry standard cubic meter, corrected to seven percent oxygen (as determined by reference method 29 of 40 CFR Part 60, Appendix A-8).
(11)Dioxins and Furans. Emissions of dioxins and furans from each municipal waste combustor shall not exceed:

(A)60 nanograms per dry standard cubic meter (total mass) for facilities that employ an electrostatic precipitator-based emission control system, or

(B)30 nanograms per dry standard cubic meter (total mass) for facilities that do not employ an electrostatic precipitator-based emission control system.

Compliance with this Subparagraph shall be determined by averaging emissions over three test runs with a minimum four hour run duration, performed in accordance with reference method 23 of 40 CFR Part 60, Appendix A-7, and corrected to seven percent oxygen.

(12)Fugitive Ash.

(A)On or after the date on which the initial performance test is completed, no owner or operator of a municipal waste combustor shall cause to be discharged to the atmosphere visible emissions of combustion ash from an ash conveying system (including conveyor transfer points) in excess of five percent of the observation period as determined by reference method 22 (40 CFR Part 60, Appendix A-7), except as provided in Part (B) of this Subparagraph. Compliance with this Part shall be determined from at least three 1-hour observation periods when the facility transfers fugitive ash from the municipal waste combustion unit to the area where the fugitive ash is stored or loaded into containers or trucks.

22:23                                                               NORTH CAROLINA REGISTER                                           JUNE 2, 2008

2095

Document info
Document views569
Page views569
Page last viewedMon Dec 05 08:53:40 UTC 2016
Pages150
Paragraphs7104
Words102637

Comments