X hits on this document

99 views

0 shares

0 downloads

0 comments

24 / 41

DATAP R O-45™

You may connect a 12V automotive light or relay to the shift light outputs. The light or relay should draw no more than 1 amp or have a rating no more than 12 Watts.

Run one single 14-20 gauge automotive style wire, any color, from the appropriate junction box position (F9-F12) to the light. Run a wire from the other side of the light to a convenient chassis ground.

TESTING:

Wiring

may

be

tested

by

using

a

special

test

feature

of

your

DATAPRO-45™. Turn off the power to the DATAPRO-45™. This may be done by turning off your master kill switch or by temporarily unplugging connector B

from your junction box.

Now, while holding down the “Channel” button on your

DATAPRO-45™, turn the power back on (or down the “Channel” button for 12 seconds. illuminate and extinguish one at a time, in each.

replace the plug). Continue holding During this time, each light should order, for approximately 2 seconds

Copyright 1999 Computech Systems Inc

19

Document info
Document views99
Page views99
Page last viewedTue Dec 06 15:08:30 UTC 2016
Pages41
Paragraphs899
Words12386

Comments