MICROWAVE/ WALL OVEN COMBINATION INSTALLATION INSTRUCTIONS
If oven is used in a new branch circuit installation (1996 NEC), mobile home, recreational vehicle, or where local codes DO NOT permit grounding through the neutral (white) wire, the appliance frame MUST NOT be connected to the neutral wire of the 4-wire electrical system. (see figure 4):
Disconnect the power supply.
Separate the green (or bare copper) and white
appliance cable wires. 3. In the junction box: connect appliance and power supply cable wires as shown in Figure 4.
4. Cabinet Installation
IMPORTANT NOTE Do not lift the oven by the door handle.
Heavy Weight Hazard
Use 2 or more people to move and install wall oven.
Failure to follow this instruction can result in injury or damage to the unit.
Cable from Power Supply
Ground Wire (Bare or Green Wire)
White Wire U.L.-Listed Conduit
Cable from appliance Figure 4
Connector (or CSA listed)
Unpack the wall oven. Remove the bottom trim taped on the oven side panel. Find the 2 anti-tip mounting screws included in the literature package. Insert the oven into the cabinet opening. Slide oven inward leaving 1½" (3.8 cm) clearance between the oven and front of cabinet (see Figure 5). Pull the armored cable through the hole for it in the cabinet and toward the junction box while moving the appliance inward. Push the oven in and against the cabinet.
4-WIRE GROUNDED JUNCTION BOX
Model and Serial Number Location The serial plate is located along the interior side trim of the oven and visible when the door is opened.
When ordering parts for or making inquires about your oven, always be sure to include the model and serial numbers and a lot number or letter from the serial plate on your oven.
1½" (3.8 cm) clearance between unit
Serial Plate Location