X hits on this document

188 views

0 shares

0 downloads

0 comments

17 / 60

Using the system

Please note the screen shot to the right of a feature indicates what the display looks like when this feature is activated.

Arm

Command: Feedback:

Press one time to Arm Lock Icon will appear, and one beep from remote

Notes:

0RESSHOLD FOR  SECONDS TO !RM the system and then activate the Panic output

Details 4HE SIREN IN THE VEHICLE WILL hCHIRPv ONCE AND THE PARKING LIGHTS will flash once. If the power door locks have been connected, the doors will lock. The system will automatically check for errors when it ARMS 4HE  WAY REMOTE WILL hCHIRPv ONCE AND THE LOCK ICON APPEAR TO confirm arming. If no arm confirmation is received, the remote will give the Out-Of-Range signal.

If errors are found when arming: If an alarm trigger zone – such as a door, the trunk, the hood, or a SENSOR WAS ACTIVE AT THE TIME OF ARMING THE SYSTEM WILL hBYPASSv OR ignore, this trigger zone. This allows the system to continue to protect your vehicle using the remaining trigger zones. You are notified of this active zone immediately after arming the system. 4HE SIREN IN THE VEHICLE WILL hCHIRPv AGAIN AFTER ARMING 4HE 3TATUS ,%$ indicator in the vehicle will blink in a pattern to indicate the active zone number error which was found (See Table of Zones). The 2-way REMOTE CONTROL WILL SOUND A SHORT hERRORv TONE AND THE TEXT WILL DISPLAY the active zone..

© 2008 Directed Electronics. All rights reserved.

17

Document info
Document views188
Page views188
Page last viewedWed Jan 18 19:08:27 UTC 2017
Pages60
Paragraphs1072
Words11447

Comments