X hits on this document

122 views

0 shares

0 downloads

0 comments

19 / 60

minutes and 1 minute of runtime remaining, it sends the 2-way remote control a paging signal.

Points to remember: If the hood is open or if the brake pedal is pressed, the vehicle will not remote start. The remote start shuts down:

s s s

s

When the brake pedal is pressed. The hood is opened. When the remote start command is sent again from a remote control. 7HEN THE RUNTIME EXPIRES

To drive your vehicle after it has been remote started:

  • 1.

    'ET IN WITHOUT STEPPING ON THE BRAKE

  • 2.

    Insert the ignition key and turn it to the ON position.

  • 3.

    Now, step on the brake.

The remote control will play the remote start shutdown tone. You have now taken direct control from the remote start system.

Valet Take-Over 4HE 6ALET 4AKE /VER FEATURE ALLOWS THE VEHICLE TO REMAIN RUNNING AFTER the key has been removed from the ignition. This feature is useful for OCCASIONS WHEN YOU WISH TO EXIT AND LOCK THE VEHICLE FOR SHORT PERIODS of time, but would like to leave the motor running and the climate

controls on. 4O ENABLE 6ALET TAKE OVER WHILE THE VEHICLE IS RUNNING PRESS

1 time

and the parking lights will flash after a couple of seconds turn off the IGNITION AND THE CAR SHOULD STAY RUNNING /NCE YOU EXIT THE VEHICLE YOU can lock the system and the car will remain running. If the vehicle shuts down, then the unit did not enter valet take-over mode.

© 2008 Directed Electronics. All rights reserved.

19

Document info
Document views122
Page views122
Page last viewedSun Dec 04 01:53:00 UTC 2016
Pages60
Paragraphs1072
Words11447

Comments