X hits on this document

129 views

0 shares

0 downloads

0 comments

28 / 60

Additional remote start features

Manual Transmission

If the vehicle has a manual transmission the proper steps must be fol- lowed before leaving the parked vehicle or the remote start feature is disabled .

1.

Make sure the engine is running and the doors on the vehicle are closed.

  • 2.

    Put the transmission in neutral.

  • 3.

    Press on the brake in the vehicle.

  • 4.

    Apply the emergency brake.

  • 5.

    Release the brake.

Note: Pressing the brake pedal again after this step will disable the remote start feature.

  • 6.

    Within 15 seconds activate the remote start from the remote.

  • 7.

    The parking lights flash 5-times confirming that the remote start is active. If the parking lights do not flash 5-times, then repeat steps 1 - 6.

  • 8.

    Turn off the ignition (the car stays running when key is turned off).

  • 9.

    %XIT THE VEHICLE

  • 10.

    Arm the alarm (the vehicle should shut off when arming the sys- tem).

You can now remote start the vehicle. If a door is opened or the alarm IS TRIGGERED BEFORE THE NEXT REMOTE START ACTIVATION THE SYSTEM WILL NOT remote start.

Note: 4O ENABLE 6ALET TAKE OVER WITH A MANUAL TRANSMISSION OPEN THE door and enter into manual transmission mode, as described above. 4HE PARKING LIGHTS mASH ONE TIME WHEN ENTERING 6ALET TAKE OVER /NCE YOU EXIT THE VEHICLE YOU CAN LOCK THE SYSTEM AND THE CAR WILL REMAIN

28

© 2008 Directed Electronics. All rights reserved.

Document info
Document views129
Page views129
Page last viewedMon Dec 05 12:30:42 UTC 2016
Pages60
Paragraphs1072
Words11447

Comments