X hits on this document

131 views

0 shares

0 downloads

0 comments

31 / 60

still enabled). You can still remote start the vehicle after the turbo timer has timed out and shut off the vehicle. For safety reasons, if a door is opened or if the ALARM IS TRIGGERED WHILE YOU ARE AWAY THE REMOTE START EXITS THE MANUAL transmission mode and does not remote start until the MTS sequence is re-initiated.

Note: An optional push button can be hard wired to the (-) activation INPUT ( ON THE REMOTE START 4HIS ALLOWS THE USER TO ACTIVATE THE turbo timer without having to use the remote.

When the vehicle is running follow the procedures listed above, but instead of pressing the remote, press the push button the appropriate number of times to activate the remote start (factory setting is for 1 pulse). The remote emits the remote start confirmation tone, after which YOU CAN TURN OFF THE IGNITION AND EXIT THE VEHICLE 4HE CAR REMAINS RUN- ning for the pre-programmed amount of time.

Runtime check

Command

Feedback: Notes:

:

While the remote start is running, press and then Hold for 1.5 seconds. 4EXT READS RUNTIME AND DISPLAYS TIME LEFT This feature is only available on the 2way remote. two-times,

Runtime reset

Command

: While the remote start is running, press

one-time and

then

.

Feedback: Notes:

Remote start ON tones. Re-starts the remote start runtime counter if remote start

is active. Note: If remote start is not active, the 2-WAY

© 2008 Directed Electronics. All rights reserved.

31

Document info
Document views131
Page views131
Page last viewedMon Dec 05 19:15:48 UTC 2016
Pages60
Paragraphs1072
Words11447

Comments