X hits on this document

155 views

0 shares

0 downloads

0 comments

32 / 60

remote will respond with error tone.

Rear defogger

Command:

Press

four times, and then

. (Only after remote

start is on.)

Feedback:

$EFOGGER ICON APPEARS ON REMOTE AND TEXT READS $EFROST

Notes:

On. While the remote start is running the defroster will manu-

ally be turned on for one remote start cycle. When the remote start shuts down, the defroster will work normally. The defroster turns on when the temperature inside the vehicle is 55 degrees or below when this feature is wired and enabled.

Smart start

Command: Feedback:

Notes:

Press

three-times and then

press

.

4HE VEHICLES PARKING LIGHT mASH  TIMES FAST AND THE TEXT on the 2way remote reads Smart Start On Enables or disables the SmartStart feature. The smart start feature of this system will allow you to have the remote start activate when the vehicle reaches a certain temperature (hot or cold) or a certain voltage. The fac- tory setting for temperature high is 100 °F the setting for low is 0 °& 4HE VOLTAGE SETTING IS FOR 6 These settings can be adjusted or turned off by your

installer when using the Bitwriter.

To activate the Smart Start Mode with a manual transmission:

  • 1.

    Enter the MTS procedure.

  • 2.

    %XIT THE VEHICLE AND PRESS THE

button on the remote (the vehicle

32

© 2008 Directed Electronics. All rights reserved.

Document info
Document views155
Page views155
Page last viewedFri Dec 09 10:31:42 UTC 2016
Pages60
Paragraphs1072
Words11447

Comments