X hits on this document

140 views

0 shares

0 downloads

0 comments

41 / 60

Diagnostics

The microprocessor at the heart of your system is constantly monitoring all of the switches and sensors connected to it. It is designed to detect any faulty switches and sensors and prevent them from disabling the entire system. The microprocessor will also record and report any trig- gers that occurred during your absence.

Refer to System Status Chirps and Table of Zones sections of this guide for diagnostic information.

Last trigger

Press

three times and then hold for 1.5 seconds. The display scrolls

last trigger and the remote recalls the last zone that has triggered the

security system.

Arming

If the security system is armed at the same time that an input is active (such as a door opening or sensor triggering), you will hear one siren chirp to indicate arming and a second siren chirp to indicate Bypass Notification.

A Bypass Notification chirp means that the security system ignores the input that was active when the system was armed, until that input ceases. Three seconds after that input ceases, the security system will resume normal monitoring. For example IF YOUR VEHICLE HAS AN INTERIOR LIGHT EXIT DELAY AND YOU ARM your security system before the interior light turns off, you may hear a second Bypass Notification chirp. Once the light turns off, the security system resumes normal monitor- ing.

© 2008 Directed Electronics. All rights reserved.

41

Document info
Document views140
Page views140
Page last viewedThu Dec 08 00:54:04 UTC 2016
Pages60
Paragraphs1072
Words11447

Comments