X hits on this document

121 views

0 shares

0 downloads

0 comments

42 / 60

Note: Bypass Notification does not occur when the system is in Silent Mode or if the notification chirps have been programmed off by the installer.

Disarming

%XTRA CHIRPS HEARD WHEN DISARMING THE SYSTEM ARE THE 4AMPER !LERT If four chirps are heard when disarming the system, then the security system was triggered in your absence.

If five chirps are heard when disarming the system, the system was TRIGGERED SO MANY TIMES THAT THE .UISANCE 0ROTECTION #IRCUITRY HAS bypassed the intended zone. In either case, the status LED will indicate which zone was involved (see Table of Zones).

The security system will retain this information in its memory, and chirp FOUR OR lVE TIMES EACH TIME IT IS DISARMED UNTIL THE NEXT TIME THAT THE ignition is turned on.

Note concerning low battery alert: When the batteries in the remote are low the alarm will give an additional chirp when disarming to let you know its time to change the battery in the remote.

System status chirps

4HE SIREN WILL CHIRP WHEN ARMINGDISARMING THE SYSTEM 4HE PATTERN OF chirps will audibly report the system’s status as described below.

Action Arm Arm Disarm

Number of Chirps 1 1 (3-second delay) + 1 2

Description System armed System armed with bypass notification System disarmed

42

© 2008 Directed Electronics. All rights reserved.

Document info
Document views121
Page views121
Page last viewedSun Dec 04 00:28:58 UTC 2016
Pages60
Paragraphs1072
Words11447

Comments