X hits on this document

151 views

0 shares

0 downloads

0 comments

44 / 60

For example: If zone 3 was active or triggered, the LED will blink three times with a two-second pause. Then it will blink three times again, and repeat until the ignition is turned on.

Nuisance prevention® circuitry

9OUR SYSTEM HAS $IRECTEDS .UISANCE 0REVENTION #IRCUITRY .0#  )T prevents annoying repetitive trigger sequences due to faulty door pin switches or environmental conditions such as thunder, jackhammers, airport noise, etc.

For example: If the alarm triggers three times within a 60-minute period and each time the same sensor or switch triggers the alarm, NPC will interpret those triggers as false alarms. After the third trigger, NPC ig- nores, or bypasses, that sensor or switch (along with any other sensors or switches sharing the same zone) for 60 minutes.

If the bypassed sensor tries to trigger the security system while it is being bypassed, the 60-minute bypass period will start over. This ensures that a sensor that is continually being triggered will remain bypassed.

The vehicle doors are protected by NPC differently. If your security system is triggered by an open door for three full cycles, the system will bypass the doors until the trigger ceases.

Remote Start

This system can provide you with information to indicate what the problem is when using the remote start. When the remote start is activated and fails to engage, count the parking light flashes to determine the problem. The parking lights will flash between 5 - 8 times to indicate what caused the no start situa-

tion. s s

  • mASHES BRAKE WIRE IS ACTIVE

  • mASHES HOOD PIN IS ACTIVE

44

© 2008 Directed Electronics. All rights reserved.

Document info
Document views151
Page views151
Page last viewedFri Dec 09 05:08:21 UTC 2016
Pages60
Paragraphs1072
Words11447

Comments