X hits on this document

117 views

0 shares

0 downloads

0 comments

46 / 60

Power saver mode

System

Your system will automatically enter Power Saver Mode while armed or IN 6ALET -ODE AFTER A PERIOD OF TIME IN WHICH NO OPERATION HAS BEEN performed. This lowers the current draw on the vehicle’s battery. Power Saver Mode takes over under the following conditions:

Power Saver when the system is armed: After the system has been armed for 24 hours the LED will flash at half its normal rate, decreasing the system’s current draw.

Power Saver in Valet Mode: 7HEN THE SYSTEM ENTERS 6ALET -ODE THE Status LED on the Responder LE control center illuminates steadily. If the vehicle is not used (ignition is not turned on) for a one hour period while THE SYSTEM IS IN 6ALET -ODE THE STATUS ,%$ WILL SHUT OFF )F THE SYSTEM REMAINS IN 6ALET -ODE THE ,%$ WILL COME BACK ON THE NEXT TIME THE ignition is turned on and then back off.

2-way remote

Your Responder LC 2way remote control has a feature called remote power save mode. When programmed ON under remote options, the remote will conserve power by disabling the paging function if unused for more than 72 hours. Pressing any button on the remote will restore the paging function.

The default setting is ON. See Remote control programming section of this guide or ask your dealer for details on how to program.

46

© 2008 Directed Electronics. All rights reserved.

Document info
Document views117
Page views117
Page last viewedSat Dec 03 07:07:26 UTC 2016
Pages60
Paragraphs1072
Words11447

Comments